MK Diamond MK-145 220 Volt - Manual (Page 18)

MK Diamond Products Inc. Customer Service Department (800) 421-5830
MK-145 Revision 09/04, Effective date – September 23, 2004 Page 18
SETUP, ADJUSTMENT and OPERATION:
ADJUSTMENT AND OPERATION:
Cutting Straight Edges:
STEP ACTION
1. Position Adjustable Cutting Guide
a) Loosen the two (2) Retaining Knobs
b) Align the Measuring Arrow of the Adjustable
Cutting Guide to the cut length indicated on the
Cutting Table Ruler
c) Retighten the Retaining Knobs
2. Position the Tile
a) Position the tile against the Adjustable Cutting
Guide
3. Set the Blade Guard
a) Set Blade Guard above the top of the
tile
4. Turn on the MK-145
a) Turn on the MK-145
b) Verify Cooling Water Flow around Blade Guard
DO NOT FORCE TOOL, it will do the job better and safer at the rate for
which it was designed.
5. Cutting Tile
a) Feed the tile into the Diamond Blade with a
steady even pressure (forcing the tile will cause
the blade to slow which could cause motor
overheating)
6. Cutting Complete
a) Turn saw off when cutting is complete
Measuring Arrow
Aligned with Ruler
Tile Positioned
Against Guide
Blade Guard Set
Switch ON
Off Position
Feed Tile Slowly