MK Diamond BX-4 - Manual (Page 12)

BX-4 12
I OFF
PUMP SWITCH
TRANSPORT
The BX-4 weighs approximately seventy (70) pounds (With the
Movable Cutting Table), making transport easy.
Due to its lightweight construction, the BX-4 is designed to be
carried by the handles at the front & back of the saw. Simply
lock (1) the spring assisted Cutting Head in position (2), by
tightening the Tri-Knob. Grasp the frame by the lower front and
rear cross members (3,4). Lift and transport the BX-4 to the
desired work location.
• Slide Table Lock to engage or disengage pin into or out of
notches in the Side Rail for transportation or operation.
ASSEMBLY
Follow the assembly instructions to prepare your BX-4 for
operation.
1. MOVABLE CUTTING TABLE INSTALLATION:
• Identify front side of Cutting Table (5).
• Seat Roller Wheels (6) of the Movable Cutting Table
within the guide rails.
• Verify correct seating and ease of Cutting Table movement.
See Maintenance Section if problems arise.
UNPACKING, TRANSPORT & ASSEMBLY
1
NOTE
Lock the Cutting Head in the DOWN position, and remove
the Movable Cutting Table when transporting the BX-4.
Always observe safe lifting practices when lifting the BX-4.
CAUTION
5
6
3
2
Table
Lock
4