MK Diamond BX-4 - Manual (Page 15)

BX-4 15
SETUP, ADJUSTMENT & OPERATION
PRE-START INSPECTION:
The pre-start inspection should be performed before
beginning any job.
• Inspect Blade for damage (1). Verify that the Blade is
correct for the material being cut.
• Inspect Wooden Strip (2) for excessive grooves.
• Ensure that the Movable Cutting Table (3) moves freely.
See Maintenance Section if problems arise.
• Inspect other areas for damage, including the Frame
Assembly (4), Motor Mount Assembly (5), Handle
and Cord Assembly (6) and Table Assembly (7).
If the Diamond Blade shows signs of fatigue cracking,
replace the blade before starting work.
NOTE
In order to avoid breaker tripping, a 20-amp circuit breaker
should be used.
1
CAUTION
3
5
6
7
4
2