MK Diamond BX-4 - Manual (Page 27)

BX-4 27
MAINTENANCE & TROUBLESHOOTING
5. MOVABLE CUTTING TABLE WHEEL CHANGE-OUT:
NOTE: All four (4) Movable Cutting Table Roller Wheels
should be replaced at the same time
(MK Diamond Part # 133090).
• Place Movable Cutting Table on work bench with
Roller Wheels up.
• Using a 1/2-inch wrench to hold hex nut, hold Roller
Wheel rotating nut stationary, rotate the Roller Wheel
counter-clockwise with 3/16” hex key wrench to remove.
• Prepare for installation of new Roller Wheels by
cleaning the Roller Wheel holes.
• Install Wheel/Washer assembly into Movable Cutting
Table.
• Using a 1/2-inch wrench, rotate the Roller Wheels
counter-clockwise to install Roller Wheel Retaining Nut.
NOTE: When installing the Retaining Bolt, Do Not cross-
thread and DO NOT over tighten the nut.
• Lubricate Roller Wheels with light oil (WD-40 or
3-in-1, etc.)
• Install Movable Cutting table move table to check for
smoothless of movement.