MK Diamond BX-4 - Manual (Page 26)

BX-4 26
MAINTENANCE & TROUBLESHOOTING
4. DIAMOND BLADE CHANGE-OUT:
• Remove Retaining Screw (1) and Outer Flange (2):
Hold Shaft Wrench (3) stationary. Rotate Retaining
Screw counter-clockwise to loosen screw.
• Remove Blade from Motor Shaft.
• Seat Blade on the Inner Flange (4) under Blade
Guard and onto Motor Shaft. Note the
indicated rotation direction.
• Install Outer Flange (2) and Retaining Screw (1):
Hold Shaft Wrench (3) stationary. Rotate and tighten
Retaining Screw (1) clockwise.
NOTE: When installing the Retaining Screw, do not
“cross-thread” and DO NOT over tighten the screw.
Disconnect the tool before servicing and when changing
accessories, such as blades, bits, cutters, and the like.
WARNING
2
1
3
4