MTS TestLine - Manual (Page 108)

Run the Test
1. Run the test.
a) If necessary, click the Reset button to reset the interlock.
b) Ensure that both the HPU and HSM are on high power.
c) Click the Run (green arrow) button.
2. Verify that the test parameters are correct, and then click Run Test.
The 1000 cycle test requires you to click Run Test after every 200 cycles.
3. After the test has run all 1000 cycles, click Close.
Review the Results
At the conclusion of the test, click any of the Results tabs found in the MTS TestSuite main window
for test details.
108 | MTS TestLine Test System Operation
Running the Example HCF Test