MTS TestLine - Manual (Page 93)

This introduces a force waveform to the specimen.
a) In the Station Manager main window, click the Function Generator button.
b) Set up a force waveform using the following parameters:
• Channel — Ch1 (or other depending on your configuration)
• Control Mode — Force
• Command Type — Cyclic
• Target Setpoint — +0.3000 kN
• Amplitude — 0.2000 kN
• Frequency — 1 Hz
• Wave Shape — Ramp
• Compensator — None
3. Open a Station Manager Scope.
Click the Scope button in the Station Manager main window.
4. Set up the Scope.
MTS TestLine Test System Operation | 93
Running the Example HCF Test