New Era NE-1600 Multi-Phaser Programmable Syringe - Manual (Page 44)

New Era Pump Systems Inc. WWW.SYRINGEPUMP.COM Model NE-1600/NE-1800 Multi-Phaser™
Publication #1200-02 39 8/1/14
OF = Trigger off (disabled)
TTL I/O DIRECTIONAL CONTROL INPUT SETUP
DIN [ 0 | 1 ]
Set/query directional control input setup
Settings => 0 = Falling edge: Infuse, Rising edge Withdraw
Same as "dr:rE" setting from the keypad.
Use this setting with the CBL-TTL-1, reciprocating pump cable, to create a 2 pump
continuous infusion system
1 = Falling edge: Withdraw, Rising edge Infuse
Same as "dr:dU" setting from the keypad.
Use this setting with the CBL-TTL-1, reciprocating pump cable, to create a 2 pump
dual pumping system
PUMP MOTOR OPERATING TTL OUTPUT CONFIGURATION
ROM [ <on-off> ]
Set/query Pump Motor Operating TTL output configuration (TTL pin 7)
Settings => 0 = Output is logic high only when the pump motor is operating (pumping).
1 = Output is logic high when the pump motor is operating (pumping) or when the
Pumping Program is executing a pause timer.
SET KEYPAD LOCKOUT
LOC [P] [ <on-off> ]
Set/query keypad lockout mode. Set keypad lockout disables changing any settings from the keypad
unless the "Lockout Disable Key" is inserted.
P [ <on-off> ]
Set/Query Program Entry Mode Lockout. Set Program Entry Mode Lockout prevents inexperienced
users from entering “Program Entry Mode” from the keypad. When enabled, only the Phase 1 ‘Rate’,
‘Volume’ and Pumping Direction can be changed. Cannot be enabled when the Pumping Program is
currently programmed with a multiple Phase Program.
SET KEYPAD AND NOTIFICATION BEEP
BP [ <on-off> ]
Set/query keypad and notification beep mode. Set beep enables or disables beep mode.
9.4.4 General Control and Status Commands
TTL I/O OUTPUT SETTING
OUT <n> <TTL level>
Sets TTL level on user definable output pin on the ‘TTL I/O’ connector.
<n> Indicates pin number on ‘TTL I/O’ connector. Valid value: 5 (Program Output pin)
Query is not applicable.
TTL INPUT QUERY
IN <n>
Queries TTL level of pin on ‘TTL I/O’ connector. Set is not applicable.
<n> Indicates pin number on ‘TTL I/O’ connector. Valid values: 2, 3, 4, and 6.
Response: <TTL level>
BUZZER
BUZ [ 0 | { 1 [ < n > ] } ]
Sets / queries buzzer
Set: 0 = Turn buzzer off;
1 = Turn buzzer on
if <n> specified
If <n> = 0, buzzer beeps continuously,
otherwise buzzer beeps <n> times
if <n> not specified, buzzer sounds continuously