RKI Instruments SC-01 - Manual (Page 10)

5 • Description SC-01 Operator’s Manual
Protective Rubber Boot
A rubber boot installed over the case helps protects the SC-01. The boot
allows viewing of the display and alarm lights and access to the control
buttons, battery cover, sensor, and belt clip. The sensor must be removed
to remove the protective rubber boot.
Case
The SC-01’s sturdy, high-impact plastic case is radio frequency (RF)
resistant and is suitable for use in many environmental conditions, indoors
and out. It is dust proof and weather resistant.
A clear plastic window through which the LCD can be viewed is located on
the front of the case. A frosted plastic lens above the LCD allows viewing of
the alarm lights. The three control buttons are below the LCD. The left
button is labeled “AIR
▼ ”, the middle button is labelled “ ▲ DISP” and the
right button is labeled “POWER”. Below the control buttons on the right
side of the front, the buzzer is located inside the case. A hole with a
protective membrane allows the buzzer sound out of the case.
The sensor protrudes out the bottom left of the case. The battery cover is
located to the right of the sensor and allows access to the batteries. The IR
port is located on the right side of the case.
There are two threaded holes on the back of the case. These are used to
mount the alligator clip or the optional belt clip.
Threaded
Inserts
Figure 2: SC-01 Rear View