RKI Instruments SC-01 - Manual (Page 23)

SC-01 Operator’s Manual Operation in Measuring Mode • 18
Using the SC-01 With the Optional Extender Cable
The SC-01 can be used with an optional extender cable in applications
where it is necessary that the sensor be remote from the instrument. The
sensor is removed from the instrument and the cable is connected to the
instrument on one end and to the sensor on the other.
Do the following to install the extender cable.
1. Verify that the SC-01 is off.
2. Grasp the rubber guard on the sensor retainer firmly and turn it
counterclockwise about 1/8 turn. A yellow line on the rubber guard will
indicate the proper amount of rotation by lining up with a yellow line on
the instrument body that indicates “UNLOCK”.
3. Pull the sensor retainer away from the SC-01 and it will slide out of the
SC-01.
Sensor
POWER
RKI
DISP
AIR
Extender Cable
Cable Retainer
Sensor Retainer
Figure 5: The SC-01 With an Extender Cable