Rockwell Automation 281E ArmorStart EtherNet/IP - Getting Started User Manual
Page 14
14 ArmorStart EtherNet/IP Distributed Motor Controller Getting Started
Publication 280E-QS001B-EN-P – February 2011
Figure 17 – Receptacle Connections for Incoming Control Power – 24V DC Only
Figure 18 – Receptacle Connections for Source or Control Brake – Bulletin 284E
only
Figure 19 – Receptacle Connections for Motor Connector (M22) – Bulletin 280E/
281E: 3 Hp or less and Bulletin 284E: 5 Hp or less
Figure 20 – Receptacle Connections for Motor Connector – 10 Hp or greater (M35) –
Bulletin 280E/281E only
Pin 1: +24V DC unswitched (A3) (red)
Pin 2: Common (A2) (black)
Pin 3: PE (green)
Pin 4: Not used (blank)
Pin 5: +24V DC switched (A1) (blue)
Pin 6: Not used (white)
Pin 1: L1 (black)
Pin 2: GND (green/yellow)
Pin 3: L2 (white)
Pin 1: T1 (black)
Pin 2: T2 (white)
Pin 3: T3 (red)
Pin 4: Ground (green/yellow)
Pin 1: T1 (black)
Pin 2: Ground (green/yellow)
Pin 3: T3 (red)
Pin 4: T2 (white)