Rockwell Automation 281E ArmorStart EtherNet/IP - Getting Started - Manual (Page 29)

Publication 280E-QS001B-EN-P – February 2011
ArmorStart EtherNet/IP Distributed Motor Controller Getting Started 29
Bulletin 280E/281E
Troubleshooting The following flowchart for Bulletin 280E/281E units, is provided to aid in
quick troubleshooting.
Figure 37 - Bulletin 280E/281E Control Module LED Status
ATTENTION: Only qualified personnel familiar with adjustable frequency
AC drives and associated machinery should plan or implement the
installation, startup, and subsequent maintenance of the system. Failure
to comply may result in personal injury and/or equipment damage.
ATTENTION: This drive contains electrostatic discharge (ESD) –
sensitive parts and assemblies. Static control precautions are required
when installing, testing, servicing, or repairing this assembly. Component
damage may result if ESD control procedures are not followed. If you are
not familiar with static control procedures, refer to Allen-Bradley
®
Publication 8000-4.5.2, Guarding against Electrostatic Damage, or any
other applicable ESD protection handbook.
ATTENTION: An incorrectly applied or installed drive can result in
component damage or a reduction in product life. Wiring or application
errors, such as undersizing of the motor, incorrect or inadequate AC
supply, or excessive ambient temperatures may result in malfunction of
the system.
Faulted Display
Motor will
not Start
See
Table 10
See
Table 8
Fault
LED
Network
LED
Yes
No
See
Table 6