Rockwell Automation 442L-SFZNMN SafeZone Mini Safety Laser Scanner User Manual - Manual (Page 35)

Rockwell Automation Publication 10000337275 Ver 01—October 2014 33
Chapter 5 Mounting
Height of the scan plane
Mount the SafeZone Mini such that the scan plane is at a maximum height of 200 mm (7.87 in.)!
In this way also persons lying down will be reliably detected. Tilting the protective field so that objects with a diameter of
200 mm (7.87 in.)are not detected, is not allowed. We recommend aligning the scan plane horizontally at 70 mm
(2.76 in.)
Fig. 24: Mounting height [mm (in.)]
Note To produce the optimal scan plane, you can also mount the SafeZone Mini reversed.
Methods of preventing
unprotected areas During mounting the SafeZone Mini, areas may be found that are not covered by the safety laser scanner ( ).
Fig. 25: Unprotected areas
Prevent or secure unprotected areas!
•
Mount the SafeZone Mini such that there are no unprotected areas.
• For mobile applications, if the vehicle is accelerated to a maximum velocity of 0.3 m/s (11.8 in.s) in less than three
seconds when in operation, you must prevent personnel from entering the unprotected areas by means of mechanical
trim panels, switch strips or fitting the SafeZone Mini in the vehicle trim panels.
ATTENTION
Set protective
field length
190 (7.48)
150 (5.91)
Set protective
field length
110 (4.33)
150 (5.91)
?

ATTENTION