Rockwell Automation 442L-SFZNMN SafeZone Mini Safety Laser Scanner User Manual - Manual (Page 39)

Rockwell Automation Publication 10000337275 Ver 01—October 2014 37
Chapter 5 Mounting
Fig. 32: Mounting with mounting kit 2
 Mount mounting kit 1 or 2 to the SafeZone Mini.
 Mount the mounting kit 4 on the mounting surface.
 Fit the centering pin [4 mm (0.16 in.)] in the central hole on mounting bracket 4.
 Fit mounting kit 3 to mounting kit 4 and mount it using two fixing screws M4 ×
10.
 Then mount the SafeZone Mini on mounting kit 3 with the aid of the threaded holes in mounting kit 1.
 Adjust the SafeZone Mini longitudinally and transversely and then tighten the six fixing screws on the mounting kits.
Note During mounting, please observe the dimensional drawings in Chapter 12, “Technical specifications” (see “Dimensions”
on page 61).
Information label Important information
 >On completion of mounting, you must affix the self-adhesive information label Important information supplied:
– Use only the information label in the language which the operators of the machine can read and understand.
– Place the information label such that it is clearly visible for the operators during operation. The information
label must not be covered even after additional items have been mounted.
Using multiple SafeZone Mini safety laser scanners
The SafeZone Mini is designed so that mutual interference between several safety laser scanners is unlikely. To completely
exclude erroneous switching, you must mount the safety laser scanners as shown in the following examples.
Note In any circumstance observe EN ISO 13855 when calculating the minimum distance.
Use mounting kits 1 or 2 and 3 to adjust the safety laser scanners to different angles (see Chapter 13, “Mounting kits” on
page 65).
Fig. 33: Opposite mounting
Fig. 34: Offset parallel mounting
Mounting kit 1
Mounting screws
Mounting screws
Threaded holes M4
Mounting kit 3 Mounting kit 4
Centering pin
Min. 3°
Min. 100 mm