Rockwell Automation 1757-SWKIT400 Getting Started with ProcessLogix R400.0 Quick Start - Manual (Page 15)

Getting Started with ProcessLogix R400.0 15
Publication 1757-QS040A-EN-P - October 2001
Assigning Modules to a Controller Execution Environment
Once you have configured I/O modules, you must assign them to the controller
execution environment (CEE). To assign modules to the CEE:
1. From Control Builder, select Tools
⇒
Assign.
You see the Controller Assignments window:
2. Click the IOMs tab in the Available Modules area.
3. To select all four modules, click the first module, hold down the Shift Key,
and click the last module.
4. Select CEE0101 from the Select a CEE/Link box.
5. Click Assign.
After a few seconds, the IOMs are displayed in the Assigned Modules list
box. This indicates that the I/O modules you just assigned are being used by
the selected CPM/CEE, and cannot be assigned to other CPMs.
6. After the modules are assigned, click close.