Wire the blocks – Rockwell Automation 1757-SWKIT400 Getting Started with ProcessLogix R400.0 Quick Start User Manual
Page 19
Advertising
Getting Started with ProcessLogix R400.0 19
Publication 1757-QS040A-EN-P - October 2001
Wire the blocks
Adjust your blocks to look similar to the window below.
1. Double-click the source wire. The cursor changes to a “+”.
2. Click the destination wire.
IMPORTANT
The Numeric block you created enables you to simulate a control
loop. For this loop to work properly, do not wire the
AICHANNEL block.
TIP
For additional wire segments as you draw
your wire, click the left mouse button.
Advertising