Rockwell Automation 1757-SWKIT400 Getting Started with ProcessLogix R400.0 Quick Start - Manual (Page 20)

20 Getting Started with ProcessLogix R400.0
Publication 1757-QS040A-EN-P - October 2001
Configure parameters
1. Double-click the NUMERIC block. You see the Numeric Parameters window.
2. Enter 10 in the Actual Value field.
3. Click OK.
4. Double-click the PID block. You see the PID Parameters window.
5. Click the Algorithm tab.
6. Enter these parameters:
7. Click OK.
8. Double-click the AICHANNEL block. You see the AICHANNEL Parameters
window.
9. Enter LabAI in the Module Name field.
10. Select Channel 0.
11. Click Assign Channel Block.
12. Click OK.
13. Double-click the AOCHANNEL block. You see the AOCHANNEL Parameters
window.
14. Enter LabAO in the Module Name field.
15. Select Channel 0.
16. Click Assign Channel Block.
17. Click OK.
in this field: enter:
T1 0.1
T1 High Limit 2
High Gain Limit 2
Overall Gain 0.5