Rockwell Automation 1757-SWKIT400 Getting Started with ProcessLogix R400.0 Quick Start - Manual (Page 23)

Getting Started with ProcessLogix R400.0 23
Publication 1757-QS040A-EN-P - October 2001
10. Verify that the PID OP output value (displayed near the wire) changes.
11. Change the NUMERIC.PV to 20, then 30.
12. Click Yes when prompted to Change Online Value and click OK.
Observe the OP output of the PID block for changes.
13. Close the diagram without saving your changes.
Viewing Pre-built Screens
To view the pre-built screens provided with the ProcessLogix system:
1. If the Station application program is not running, select Start
⇒
Programs
⇒
ProcessLogix Server
⇒
Station.
2. Click the text box in the upper right corner of the screen (below the
toolbar).
to view the detail screen for the: do this:
Controller 1. Type CPM0101 in the box.
2. Press [F12].
CEE 1. Type CEE0101 in the box.
2. Press [F12].
PID loop 1. Type FIC102 in the box.
2. Press [F12].
I/O modules 1. Type the name of the I/O module in the box. [for
example, LabAI]
2. Press [F12].
Alarms Click the red, blinking alarm indicator at the bottom
of the screen, or click the Alarm icon in the toolbar
menu.