Rockwell Automation 1758-RTU202 DataSite Hardware User Manual - Manual (Page 21)

Publication 1758-UM001D-EN-P - June 2011
Installing the Controller 21
4. Slide the clamp out while pushing the controller fully onto the DIN
rail (1). When the controller is properly aligned on the DIN rail (2), slide
the clamp in, so that it make direct contact with the lower edge of the
DIN rail (3).
5. Tighten the clamp screws.
Follow these steps to remove your controller from the DIN rail.
1. Loosen the two clamp screws until the clamp can slide out, taking care
not to dislodge the clamp screws from the clamp.
2. Remove the controller.
44538 44539 44540
DIN rail
1 2 3