Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 170)

Publication 1784-UM003A-EN-P – June 2003
162 Naming & Configuring Your Motion Axis
Manual Adjust
Click on this button to open the Offset tab of the Manual Adjust dialog for
online editing of the Friction/Deadband Compensation, Backlash
Compensation, Velocity Offset, Torque Offset, and Output Offset parameters.
Figure 6.43 Axis Properties - Offset Tab Manual Adjust Screen for
Axis_Servo_Drive
Note: The Manual Adjust button is disabled when RSLogix 5000 is in
Wizard mode, and when offline edits to the above parameters have not
yet been saved or applied.