Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 58)

Publication 1784-UM003A-EN-P – June 2003
50 Adding and Configuring Your 1784-PM02AE Motion Module
7. Press the Next button to proceed to the next Create Wizard screen.
Figure 3.5 Module Properties Wizard - Fault Handling
8. This screen is where you determine how faults are to be handled. The
choices are to inhibit module or to configure the module so that a loss
of connection to this module causes a major fault. Make your entries
and press the Next button to proceed to the next wizard screen.
Figure 3.6 Module Properties Wizard - Servo Update/Associated Axis