Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 69)

61 Publication 1784-UM003A-EN-P – June 2003
Chapter
4
Configuring the1784-PM16SE Card
Adding the 1784-PM16SE This chapter reviews the necessary steps for configuring the 1784-PM16SE
motion card. Much of this information is the same as for adding and
configuring the 1784-PM02AE as discussed in the previous chapter.
To configure a 1784-PM16SE motion card:
1. In the Controller Organizer, right mouse click on I/O Configuration.
Figure 4.1 Controller Organizer | I/O Configuration| New Module
2. Or in the File menu, select New Component then Module…
Figure 4.2 File Menu | New Component | Module Selected