Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 237)

Publication 1784-UM003A-EN-P – June 2003
Configuring a Kinetix 6000 Drive 229
Connection Tab Use this tab to define controller to module behavior.
Figure 10.7 Module Properties - Connection Tab
On this tab, you can:
• Requested Packet Interval – does not pertain to this drive.
• Choose to inhibit the module.
• Configure the controller so loss of the connection to this module causes
a major fault.
• View module faults.
Requested Packet Interval
This field is disabled for all motion modules (e.g., 1784-M02AE,
1784-PM16SE, and all 1394- and Ultra3000, Kinetix 6000, and 8720 drives).
TIP
The data on this tab comes directly from the controller.
This tab displays information about the condition of the
connection between the module and the controller.