Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 67)

Publication 1784-UM003A-EN-P – June 2003
Adding and Configuring Your 1784-PM02AE Motion Module 59
Major/Minor Fault Status
Internal State Status
This field displays the module’s current operational state.
• Self-test
• Flash update
• Communication fault
• Unconnected
• Flash configuration bad
• Major Fault
• Run mode
• Program mode
• (16#xxxx) unknown
If you selected the wrong module from the module selection tab, this field
displays a hexadecimal value. A textual description of this state is only given
when the module identity you provide is a match with the actual module.
Configured
This field displays a yes or no value indicating whether the module has been
configured by an owner controller connected to it. Once a module has been
configured, it stays configured until the module is reset or power is cycled,
even if the owner drops connection to the module.
Owned
This field displays a yes or no value indicating whether an owner controller is
currently connected to the module.
If you are configuring a: This field displays one of the
following:
digital module EEPROM fault
Backplane fault
None
analog module Comm. Lost with owner
Channel fault
None
any other module None
Unrecoverable
Recoverable