Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 43)

Publication 1784-UM003A-EN-P – June 2003
SoftLogix Controller 35
File Tab The File tab displays information about the project file.
The fields on this tab cannot be edited. To change the file name or path, you
must use the Save As command.
Figure 2.13 Controller Properties File Tab
Name
The name of the project file
Path
The drive and directory of the project file.
Created
The creation date and time of the project file, in the format currently selected
in the Regional Settings application in your Windows NT Control Panel.
Edited
The date and time that the project file was last edited, in the format currently
selected in the Regional Settings application in your Windows NT Control
Panel.