Connect a wire to the step – Rockwell Automation Logix5000 Controllers Sequential Function Charts Programming Manual User Manual
Page 60
Advertising
![background image](/manuals/579930/60/background.png)
Chapter 2 Program a sequential function chart
2. Clear the Use default priorities check box and select a transition.
Use the Move buttons to raise or lower the priority of the transition.
3. When all the transitions have the correct priority, click OK.
When you clear the Use default priorities check box, numbers show the priority
of each transition.
You may have to reposition a wire after you connect it to a step. This example
shows how to go to Step_001 from Tran_003.
Connect a wire to the step
60
Rockwell Automation Publication 1756-PM006F-EN-P - October 2014
Advertising