Rockwell Automation Logix5000 Controllers Sequential Function Charts Programming Manual - Manual (Page 61)

Program a sequential function chart Chapter 2
Click the lower pin of the transition that signals the jump.
Then click the top pin of the step to which you want to go. A green dot shows a valid connection point.
Typically, the resulting connection orients itself along the center of the flowchart and is hard to see.
To make the jump easier to read, drag its horizontal bar above the step to which the jump goes. You may also
have to reposition some of the SFC elements.
If a wire gets in the way of other parts of your SFC, hide the wire to make the SFC
easier to read. To hide a wire, right-click the wire and then click Hide Wire.
To see the SFC element to which the wire goes, click the grid location on the wire.
Hide a wire
Rockwell Automation Publication 1756-PM006F-EN-P - October 2014 61