Rockwell Automation 2711P Creating Modbus Applications - Manual (Page 46)

Publication 2711P-UM002B-EN-P - March 2007
46 Installing KEPServer Drivers on Terminal
Upgrade Firmware using a
Network (Ethernet)
Connection You can upgrade the firmware in a terminal that is connected to a
desktop computer using a Serial, Ethernet or Network (using RSLinx
Enterprise) connection.
• Network connection requires RSLinx Enterprise where you
select the terminal on an existing network.
• Serial connection requires a RAS connection to be set up on
computer. During the RAS setup, you select the COM port.
• Ethernet connection requires that you enter the terminal’s IP
Address.
Both the Serial and Ethernet connection requires the PanelView Plus
File Transfer Utility running on the terminal and should only be used
when other methods fail.
This section shows how to upgrade firmware in a PanelView Plus
terminal using a Network connection via Ethernet communications.
1. Start the Firmware Upgrade Wizard. Select Start>Rockwell
Software>RSView Enterprise>Firmware Upgrade Wizard.