Rockwell Automation 2090-Series Circular-DIN Connector Kits, Flange Kits, and Crimp Tools - Manual (Page 16)

Rockwell Automation Publication 2090-IN042A-EN-P - May 2011
16
Crimping a Contact
See Table 2 on page 20 and 21 to determine the correct contact size in relation to
the wire size being used.
1. Insert the wire into the contact (actual contacts will vary).
2. Feed the contact and wire as far as possible through the indenters to the
stop in the locator cartridge.
The locator cartridge provides for the exact positioning of the contact.
ATTENTION: Do not crimp or gauge objects not intended for the
crimp tool.
Do not crimp solid material exceeding 35 Hot Rolled Coil (HRC) (for
example, steel).