Rockwell Automation 2090-Series Circular-DIN Connector Kits, Flange Kits, and Crimp Tools - Manual (Page 17)

Rockwell Automation Publication 2090-IN042A-EN-P - May 2011
17
3. Close the crimp tool handles until the end-stops touch, and then release
the handles to allow the crimp tool to open.
Note: If the crimp tool does not open, the handles were not closed far
enough for the crimp to be successful. Continue to close the handles until
the end-stops touch and the crimp tool is able to open.
4. Remove the wire and contact from the locator cartridge.
IMPORTANT Perform a pull test according to BS EN 60352-2 , Table 4, for the first
crimp, and periodically throughout multiple crimpings.