Rockwell Automation 2090-Series Circular-DIN Connector Kits, Flange Kits, and Crimp Tools - Manual (Page 9)

Rockwell Automation Publication 2090-IN042A-EN-P - May 2011
9
Parts Included with the 8-point Crimp Tool
These parts are included with the crimp tool:
• one crimp tool
• two locators (requires assembly onto the crimp tool)
• one 2 mm calibration gauge
• two Allen wrenches (used to assemble a locator onto the crimp tool)
• one lithium battery (installed)
Initial Assembly and Calibration of the Crimp Tool
Before the first use of the crimp tool, you must install a locator and calibrate the
crimp tool.
• To install the locator, see
Installing a Locator on page 10 .
• To calibrate the crimp tool, see
Calibrating the Crimp Tool on page 11 .
This product contains a sealed lithium battery which may need to be
replaced during the life of the product.
At the end of its life, the battery contained in this product should be
collected separately from any unsorted municipal waste.
The collection and recycling of batteries helps protect the environment
and contributes to the conservation of natural resources as valuable
materials are recovered.