Hand crimp tool, Verify the crimp tool accuracy, Go-check – Rockwell Automation 2090-Series Circular-DIN Connector Kits, Flange Kits, and Crimp Tools User Manual
Page 5: No-go-check
Rockwell Automation Publication 2090-IN042A-EN-P - May 2011
5
Hand Crimp Tool
The hand crimp tool is equipped with a double-ratchet mechanism. To open the
tool, fully close the handles. The mechanism unlocks after the handles are fully
closed. Included with the crimp tool is one 010 positioning insert.
Verify the Crimp Tool Accuracy
Before performing any work, check the crimp tool using a
.0850 GO/.0950 NO-GO test gauge.
Go-check
1. Set the crimp tool to 4 and close the handles.
2. Insert the go-gauge (green) into the crimp indenters.
The go-gauge should pass through the opening and beyond the indenter
tips.
No-go-check
1. Leave the crimp tool on setting 4 and close the handles.
2. Insert no-go-gauge (red) into the crimp indenters.
The no-go-gauge may pass partially through the indenters, but not
completely.
ATTENTION: Understand the crimp tool and how it works. Use the crimp
tool only for crimping the contacts included in the 2090-series kits.
Misuse may cause personal injury.
IMPORTANT
Do not crimp on the test gauge.
Insert Test
Gauge Here
Cat. No. 2090-TCR47-M40