Changing the battery, Maintenance – Rockwell Automation 2090-Series Circular-DIN Connector Kits, Flange Kits, and Crimp Tools User Manual
Page 18
Rockwell Automation Publication 2090-IN042A-EN-P - May 2011
18
Changing the Battery
The life of the lithium battery (CR2025) for the display is approximately 1 year,
depending on the amount of use. When you change the battery, you must
calibrate the crimp tool. Follow these steps to change the battery and calibrate the
crimp tool.
1. Pull the battery compartment open and remove the battery.
2. Dispose of the battery properly.
3. Before you install the new battery, you must follow the steps for calibrating
the crimp tool. Follow the instructions in
(starting at step
2
)
.
Maintenance
Keep the indenter tips free from abrasion and soiling. Use an air gun to remove
any dirt particles. Wipe down the crimp tool with a clean dry cloth. Ensure that
all bolts are secured with retaining rings.
This product contains a sealed lithium battery which may need to be
replaced during the life of the product.
At the end of its life, the battery contained in this product should be
collected separately from any unsorted municipal waste.
The collection and recycling of batteries helps protect the environment
and contributes to the conservation of natural resources as valuable
materials are recovered.
ATTENTION: After changing the battery, you must calibrate the
crimp tool.
IMPORTANT
We strongly recommend the following:
•
Do not use any rinsing solutions.
•
Do not lubricate.
•
Do not try to repair.
•
Do not disassemble.