Rockwell Automation 9399 A.I. SERIES INSTALLATION GUIDE - Manual (Page 33)

Installation Guide
2-6
Removing A.I. Series Software (Recall Function)
You can use the Setup program’s Recall feature to remove the activation files from your
computer's hard drive and place them back on your Master disk. The Recall function
does not delete any of the product files from your hard disk. Delete these files from
the hard disk manually, using DOS or another disk management program.
Note Make certain that your Master Disk is not write protected before attempting to recall
your software. (See the note on page 1-4 if you need help distinguishing a write
protected disk.)
If you leave the product files on your hard disk, you can re-enable the files using the
Move function in the Setup program.
To recall A.I. Series software:
1. Insert the Setup disk into your floppy drive.
2. Start the Setup program.
•
Type: A: [Enter] (Use the appropriate drive letter for your system.)
•
Type: SETUP [Enter]
You will see a screen like the following.