Rockwell Automation 9399 A.I. SERIES INSTALLATION GUIDE - Manual (Page 7)

Installation Guide
1-4
5. Setup asks for the directory in which to install the software. Either accept the
default directory (recommended) by pressing [Enter], or edit the directory name to
one of your own choosing. When you are finished editing, press [Enter].
•
If the directory name you entered does not exist, you will be prompted to allow
the Setup program to create the directory for you. Press Y [Enter] to install
the files in the selected directory. Type N [Enter] to return to the beginning of
this step.
•
After entering the directory name, you will be prompted to confirm the
installation. Type: Y [Enter] to install the files in the selected directory.
Type: N [Enter] to return to the beginning of this step.
6. The Setup program uncompresses the archived files from your A.I. Series software
disk(s), and copies them into the desired directory.
Note When switching disks, make certain that you have NOT write protected any of the
disks! (You can tell whether a disk is write protected by looking at the notch or hole in
the upper right hand corner of the disk. See the figure on the following page.)