Rockwell Automation 9399 A.I. SERIES INSTALLATION GUIDE - Manual (Page 45)

Installation Guide
2-18
the Moving value for all products to 0, then use the Edit Selected... button to set
the Moving value for the selected product to 1.
9. Click the Move button to move the activation file(s). To go back to the previous
dialog box, click the Back button. To cancel moving the activation file, click the
Cancel button. When EvMove finishes moving the selected activation files, an
EvMove report dialog box similar to the one shown below is displayed.
Click the OK button to close the EvMove report dialog box.
Moving Activation Without a Master Disk
The Move utility allows you to copy Activation files to and from any local or network
drive. You can run the Move utility from the Master disk or directly from a hard drive.
Copy the file EVMOVE.EXE from the Master disk onto your hard disk. You can then
run EVMOVE in basically the same way as described on the preceding pages, except
without the Master disk.
Making a Keydisk on a Single Floppy System
You can move activation files from a Master disk to a floppy disk even if you only have
one floppy drive. Simply use the same drive for both the source and destination. For
example, if you type
EVMOVE A A [Enter]
the utility will ask you first to insert the Master (or source) disk in A:, then the
destination floppy.