Rockwell Automation WebPak CS Software Version 1.0 - Manual (Page 13)

Getting Started 2-1
C
HAPTER
2
Getting Started
This section describes how to install the WebPakCS software and use the menus and
toolbars.
2.1 Installing the WebPakCS Software on a Personal
Computer
All files needed to install the WebPakCS software are on the WebPakCS CD-ROM
disk. Use the following steps to install the WebPakCS software.
Important: To exit installation, select Cancel from any screen or press .
Step 1. Start Microsoft Windows.
Step 2. Insert the WebPakCS software disk into the CD-ROM drive.
Step 3. From the Start Menu, select Run.
Step 4. In the Open field, type in the drive letter followed by SETUP. For example, if
your CD-ROM drive is D:, you would type D:SETUP
Follow the screen prompts.
Step 5. At the Choose Destination Location window, specify the location where you
want to install the software. The location defaults to
C:\Program Files\Rockwell Automation\WebPakCS
Select OK when the drive and directory are correct. The installation software
automatically creates the new path.
Step 6. At the prompt “Enter desired default location for WebPakCS work files,”
specify the location where you want to store the drive configuration files. The
default location is C:\WebPakCS_Work. Select OK when the drive and
directory are correct.
The program begins its installation sequence.
After creating the program group and icon, the WebPakCS software installation is
complete. The installation program automatically exits, and you return to Windows.
You should see a new entry in your Windows Start | Programs menu titled
“WebPakCS.”
Step 7. Remove the WebPakCS disk from the CD-ROM drive.
The WebPakCS software is now installed and ready to use.