Rockwell Automation WebPak CS Software Version 1.0 - Manual (Page 23)

Configuring the Drive 3-5
3.4.2 Application Edit Left View Operations
The left view contains a tree list of available right-view screens. The tree list in the left
view may or may not have collapsible nodes depending on the number of right-view
screens needed for applications. If there are collapsible nodes, then the operations in
the left view are as follows:
• Double-click on a collapsed node in the tree list to expand the node.
• Double-click on an expanded node in the tree list to collapse the node.
• Click on a node or leaf in the tree list to display the Setup/Edit window for the
selected area of the configuration.
3.4.3 Application Edit Right View Operations
Parameter entry fields consist of edit controls and combo boxes.
3.4.4 Ending an Editing Session
When you have finished editing parameters:
• Use the Save command from the File menu to save the edited configuration file to
disk.
or
• Use the Download command to write the edited configuration file to the drive.
If you select Cancel from the Configuration Editor, a message is displayed prompting
you to ignore the changes or accept them. If you ignore the changes, any new
parameter values entered during the editing session are ignored, and the session
ends.
3.5 Saving a Drive Configuration
Saving a file writes the open drive configuration to the configuration file that is shown
in the main window. This writes over the configuration file shown in the main window.
To save a file:
• From the File menu, choose Save, or click .
If the configuration file is “Untitled” or “Untitiled Upload,” the Save Configuration File
dialog box is displayed. Refer to section 3.6 for more information.