Rockwell Automation WebPak CS Software Version 1.0 - Manual (Page 9)

Introduction 1-1
C
HAPTER
1
Introduction
This section describes the computer requirements for the WebPakCS ™ software and
presents general information about the software and this manual.
1.1 About the WebPakCS Software
Use the WebPakCS software to help you develop drive configurations on your
personal computer for WebPak
™ 3000 drives. The WebPakCS software
communicates with the drive through the personal computer’s RS-232 port.
Using the WebPakCS software, you can:
• Create, modify and store WebPak drive configurations.
• Download and upload configurations to or from a WebPak drive.
• Display and change parameters in the drive.
• Control and monitor the drive.
• View waveforms in the drive.
• Read and reset the drive fault and error log.
• Send Memory Save, Memory Restore and Restore Defaults commands to a drive.
• Print a drive configuration on a printer or to a text file.
1.2 Software Requirements
The WebPakCS software requires Microsoft Windows

9x or later versions (including
Windows NT) and Internet Explorer version 5.0 or later. Make sure these programs
are installed and configured on your personal computer before attempting to install the
WebPakCS software.