Rockwell Automation WebPak CS Software Version 1.0 - Manual (Page 38)

6-2 WebPakCS Software V1.0
To switch between the fault and alarm list boxes, select the appropriate option for Log
Select.
The time stamp displays the time when the fault or alarm occurred. This time is from
the drive memory. See the WebPak 3000 OIM User Guide (D2-3445) for information
about the time stamp.
Table 6.1 describes how you can use the logs.
Figure 6.2 – Sample Alarm Log List Box
Table 6.1 – Using the Fault and Alarm Logs
To: Do the following:
Clear the fault or alarm log Select Clear.
The logged faults or alarms are deleted
from the log. This command clears only
the log that is currently displayed. Clear
does not reset drive faults or eliminate the
cause of the alarms; it simply clears the
log.
Reset the drive after a fault Select Stop/Reset in the Drive Control
window.
A reset command will be sent to the drive.
This command will not be available if the
WebPakCS software is not the control
source.
Exit the log window Select Close.