Rockwell Automation WebPak CS Software Version 1.0 - Manual (Page 35)

Monitoring and Editing Drive Parameters 5-7
5.6 Displaying a Monitor List
To display a previously saved monitor list in the WebPakCS Parameter Monitor
screen, use the Recall button. The monitor list file must have been created and saved.
Any parameters currently being displayed in the Parameter Monitor are replaced by
the list of parameters read in from the monitor list file. Figure 5.4 shows the Recall
Monitor List dialog box.
Use the following steps to read and display a Monitor List file:
Step 1. Select the drive and directory path that contains the monitor list files.
Step 2. If the monitor list files were saved using a file extension other than .MON,
select *.* in the List Files of Type box to display all of the files.
Step 3. Enter a file name, or select the file name from the displayed list.
Step 4. To recall the file and display it in the Parameter Monitor window, select OK.
To close the dialog box without recalling the monitor list file, select Cancel.
5.7 Exiting the WebPakCS Parameter Monitor
To exit the monitor list and return to the WebPakCS main window, choose the Close
command from the WebPakCS Parameter Monitor window. If a parameter list is
displayed in Parameter Monitor and it has not been saved to a file, you are prompted
to save the list. See section 5.5 for information about saving monitor list files.
Figure 5.4 – Recall Monitor List Dialog Box