Rockwell Automation WebPak CS Software Version 1.0 - Manual (Page 33)

Monitoring and Editing Drive Parameters 5-5
To send the new parameter value to the drive, choose the Send button. Send does not
exit the parameter Assignment dialog box, so you can continue to make adjustments
to the value of the selected parameter and monitor the effect on the drive.
When you have finished making adjustments to the value of a parameter, select OK to
send the parameter value to the drive and exit the Parameter Assign dialog box.
If you select Cancel, the parameter value that appears in the Parameter Assign dialog
box is ignored and the Parameter Assign dialog box is closed.
If the parameter: The dialog box looks like this: Do the following:
can be set to any
value within a range Enter the value in the box or
change the value by using the
scroll bar.
has limited options Click the arrow and select from
the options.
can be set through
the options or by
selecting a value
within a range Click the arrow and select from
the options, or enter the value in
the box.