Rockwell Automation Logix5000 Control Systems: Connect PowerFlex 70 Drives over EtherNet/IP Quick Start - Manual (Page 15)

Rockwell Automation Publication IASIMP-QS031A-EN-P - February 2012 15
Prepare the PowerFlex 70 Drive Hardware Chapter 1
Mount the 20A-B4P2A0AYNNNC0 Drive
You mount the drive upright on a flat, vertical, and level surface with considerations for
minimum mounting clearance, ambient operating temperature, debris protection, and storage.
To complete the tasks described in this chapter, mount the 20A-B4P2A0AYNNNC0 drive on a
DIN rail. For complete mounting instructions, see the PowerFlex 70 Drive User Manual,
publication
20A-UM001 .
Wire Power
1. Loosen the screw at the bottom of the
drive, as shown, and remove the cover.
2. Loosen the screws and slide the metal
plate out of the drive.
The 20A-B4P2A0AYNNNC0 drive
can use any of the following inputs:
• 208V AC three phase
• 240V AC three phase
• 400V AC three phase
• 480V AC three phase
• 600V AC three phase
In this quick start, you use 208V AC/240V AC three phase.
WARNING: Verify that all incoming power is turned off before wiring power.
Do not turn incoming power on before connecting the EtherNet/IP adapter to the drive.
PORT
MOD
NET B
NET A
STS