Rockwell Automation 20D PowerFlex 700S and 700H Frame 12 DC Bus Connector Kit - Manual (Page 13)

PowerFlex® 700S and 700H Frame 12 DC Bus Connector Kit 13
Publication PFLEX-IN022A-EN-P
4. Secure the longer end of the Z-shaped bus bar to the back side of the longest
bus bar using a M10x30 bolt, flat washer, lock washer and hex nut, as shown
below.
Important: Do not fully tighten this assembly. Final torque must be applied
after all bus bars have been installed.
Step 7: Assemble the DC+
Bus Bars Identify the following parts:
• M10 Insulated Standoff (1 - larger size) and hardware
• Long common Bus Bar (1)
• Short common Bus Bar (1)
1. Secure a M10 insulated standoff to the longest of the bus bars using a
M10x16 bolt and flat and lock washer as shown below.
Longer end
Back side
Z-shaped bus bar
Secure through second hole
from end of longer bus bar