Rockwell Automation 20D PowerFlex 700S and 700H Frame 12 DC Bus Connector Kit - Manual (Page 14)

Publication PFLEX-IN022A-EN-P
14 PowerFlex® 700S and 700H Frame 12 DC Bus Connector Kit
2. Secure a M10x25 bolt, flat and lock washers and hex nut on the tab for the
auxiliary DC+ connection.
3. Secure the smaller bus bar to the insulated standoff on the longest bus bar
using a M10x16 bolt and flat and lock washer, through the center hole in the
smaller bus bar, as shown below.
Important: Do not fully tighten this assembly. Final torque must be applied
after all bus bars have been installed.
Secure through center
hole in smaller bus bar