Rockwell Automation 20D PowerFlex 700S and 700H Frame 12 DC Bus Connector Kit - Manual (Page 18)

Publication PFLEX-IN022A-EN-P
18 PowerFlex® 700S and 700H Frame 12 DC Bus Connector Kit
Step 11: Install the DC– Bus
Bar Assembly and Fuse 1. Secure the end of the DC– bus bar assembly to the insulated standoff on the
right side support bracket attached to the air flow plate using a M10x16 bolt
and flat and lock washer as shown below.
Verify that the bus bar closest to the front of the drive is in front of the DC–
terminal on the drive and that the connection holes align.
Important: Do not fully tighten this assembly. Final torque must be applied
after all bus bars have been installed.
Top View
Verify bus bar is in
front of DC-
terminal and holes
align
Note: only left side enclosure shown.
Support Bracket