Rockwell Automation 20D PowerFlex 700S and 700H Frame 12 DC Bus Connector Kit - Manual (Page 22)

Publication PFLEX-IN022A-EN-P
22 PowerFlex® 700S and 700H Frame 12 DC Bus Connector Kit
2. Secure the first hole in the long end of the DC+ bus bar assembly to the
insulated standoff on the right side mounting rail using an M10x16 bolt and
flat and lock washer as shown below.
Verify that the bus bar closest to the front of the drive is in front of the DC+
terminal on the drive and that the connection holes align.
Important: Do not fully tighten this assembly. Final torque must be applied
after all bus bars have been installed.
Top View
Verify bus bar is in front
of DC+ terminal and
holes align
Note: only right side enclosure shown.