Rockwell Automation 20D PowerFlex 700S and 700H Frame 12 DC Bus Connector Kit - Manual (Page 23)

PowerFlex® 700S and 700H Frame 12 DC Bus Connector Kit 23
Publication PFLEX-IN022A-EN-P
3. Secure the DC+ bus bar assembly to the L-shaped bus bar in the air flow
plate using a M10x30 bolt, flat and lock washers and hex nut as shown
below.
Important: Do not fully tighten this assembly. Final torque must be applied
after all bus bars have been installed.
4. Secure the DC+ bus bar to the DC+ terminal on the drive using a M10x30
bolt, flat and lock washer and hex nut.
Important: Do not fully tighten this assembly. Final torque must be applied
after all bus bars have been installed.
Top View
Secure to DC+
terminal