Connecting transducers – Rockwell Automation 44887-PUB, 44887 Enwatch User Manual
Page 20
Advertising
Publication GMSI10-UM031C-EN-E - January 2009
16 Installing the Enwatch
14. Shut down the Enwatch unit by removing the AC power, then remove
the jumper in the center of the board (JP21) and connect the board to
an active Ethernet connection. You do not have to disconnect the
RS-232 port.
15. Open a DOS prompt on a networked computer. Type ping, then a
space, and then the first IP address.
16. You should get a return response from the Enwatch unit.
Connecting Transducers
The following sections show how to connect transducers to the Enwatch
terminals.
EXAMPLE
ping 200.100.200.100
Advertising