Rockwell Automation 44887-PUB, 44887 Enwatch - Manual (Page 31)

Publication GMSI10-UM031C-EN-E - January 2009
Installing the Enwatch 27
Then select Setup>Calibration to select “Bias Voltage” as the input type for
this transducer. The calibration should set to 1000 and the offset to 0.
Then select Setup>Collection to define a new collection specification. Select
“Transducer Check” as the transducer.
In Emonitor, define a numeric measurement definition with Vdc units and the
“Transducer Bias” collection specification.